Step-by-step instructions for performing a light gate permanent calibration.
Before conducting a light gate calibration, it is essential to ensure that the system is clean and dry.
Performing a Clean and Dry
1. Select Direct Control
2. Select Clean and Dry
Performing a Permanent Light Gate Calibration
1. Select Menu
2. Enter the passcode 123
3. Select Service Settings
4. Enter the passcode 519
5. Select Calibration
6. Select Light Gate Level Permanent Calibration
7. A message will appear asking to make sure the system is clean and dry, select continue.
8. Try running samples to confirm that error is cleared.